Erico CADWELD Cable to Ground Rod, horizontal TEE with C Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires pour les appareils électriques Erico CADWELD Cable to Ground Rod, horizontal TEE with C. ERICO CADWELD Cable to Ground Rod, horizontal TEE with Cable with Tap User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 1
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Ground Rod
Mold
Apply mold sealer
T403 CADWELD
typ. both sides.
Concentric Cable
RopeLay Cable
.13 3.2
Sleeve
Prior to making a connection, read and follow the full instruction sheet:
IPP = Grounding applications
IPP & IPRNS = Rail properties
shipped with CADWELD mold and special instructions below.
1, Insert sleeve onto cable so that cable end is 0.13 [3.2] past end of sleeve.
2, Place mold on rod and cables with run cable on top of rod and end of
4, Place T403 mold sealer around where cable/sleeves exits mold
tap cable under center of tap hole (as shown above)
3, Support mold with locking pliers or clamp on rod.
and follow standard welding procedures.
TECHNICAL SUPPORT:
www.erico.com
IP8266_A
INSTRUCTION SHEET
1 OF 1
© 2013 ERICO International Corporation
CADWELD®
Cable to Ground Rod, horizontal TEE with Cable with Tap
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
1.
www.erico.com
and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
2.
All instructions must be
completely
followed to ensure proper and safe installation and performance.
3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property
4.
damage, serious bodily injury and death.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
Vue de la page 0
1

Résumé du contenu

Page 1 - CADWELD®

Ground RodMoldApply mold sealer T403 CADWELD typ. both sides. Concentric CableRopeLay Cable.13 3.2SleevePrior to making a connection, read and follow

Commentaires sur ces manuels

Pas de commentaire