Erico Horizontal Through Parallel Side by Side Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires pour les appareils électriques Erico Horizontal Through Parallel Side by Side. ERICO Horizontal Through Parallel Side by Side User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 1
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Pack with ERICO Packing Material
Prior to making a connection, read and follow the full instruction sheets IPP, IPX,
IPRNS (included only with molds used on rail property not to rail) and the special
instructions below.
Position uncut conductors into mold slots. Conductors must be flat to make
1.
sure mold will close properly.
Pack rope in slot around conductors. Push rope in tightly with screwdriver. Cut
2.
off any excess rope.
Use ERICO packing material around rope and in between conductor openings.
3.
Make sure packing material is pushed into openings.
TECHNICAL SUPPORT:
www.erico.com
IP7038_C
INSTRUCTION SHEET
1 OF 1
© 1995, 2012, 2014
ERICO International Corporation


WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
1.
www.erico.com
and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
2.
All instructions must be
completely
followed to ensure proper and safe installation and performance.
3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property
4.
damage, serious bodily injury and death.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
Vue de la page 0
1

Résumé du contenu

Page 1 - 

Pack with ERICO Packing MaterialPrior to making a connection, read and follow the full instruction sheets IPP, IPX,IPRNS (included only with molds use

Commentaires sur ces manuels

Pas de commentaire