Erico IP6695 Type ST Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires pour les appareils électriques Erico IP6695 Type ST. ERICO IP6695 Type ST User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 1
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Prior to making a connection, read and follow the full instruction sheets IPG, IPX, IPRLBR
and special instructions below.
For better fit of mold to rail, rub mold along rail.
1.
Strip insulation off cable "X" dimension (See table).
2.
Mark cable "Y" dimension from end, place mold on cable and rail with mark even with
3.
side of mold. (See table).
Clamp mold to rail, adjust leveling screws as required.
4.
Pack all openings around cable with ERICO® mold sealer (part number T403).
5.
Pack With ERICO®
Mold Sealer
(part number T403)
Mold Width
Optional Frame
Cable Stripping Chart
Mold Width
"X" Dim. "Y" Dim.
3" [76.2 mm]
2" [50.8 mm]
1" [38.1 mm]
4" [101.6 mm]
3" [76.2 mm]
2" [50.8 mm]
TECHNICAL SUPPORT:
www.erico.com
IP6695_D
INSTRUCTION SHEET
1 OF 1
© 1995, 2005, 2012, 2014
ERICO International Corporation
Type ST
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
1.
www.erico.com
and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
2.
All instructions must be
completely
followed to ensure proper and safe installation and performance.
3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property
4.
damage, serious bodily injury and death.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
Vue de la page 0
1

Résumé du contenu

Page 1 - INSTRUCTION SHEET

Prior to making a connection, read and follow the full instruction sheets IPG, IPX, IPRLBR and special instructions below.For better fit of mold to ra

Commentaires sur ces manuels

Pas de commentaire