Erico TDSGAPC14 Pipe Mount Grounding Bus Manuel d'utilisateur télécharger pdf

Clean surface of pipe using a

T313 wire brush. Remove all

paint and oxide layers.

5/16-18 Hex Nut

Apply 12 ft-lbs (Max)

Apply anti-oxide

compound at interface

Loosen to install rods

3/8 Flat Washer

3/8 Belleville Washer

3/8 Hex Nut

Install inner hardware.

Attach clamp to pipe. Tighten hex nuts on U-bolt.

Install threaded rods by loosening hex nut on

connector. Snug hex nut by hand such that the rods

do not fall from the connector. Do not tighten hex nut.

Pipe Size Range: 1.9 to 2.5 inch actual diameter

(1.5 to 2 inch, Schedule 40)

TECHNICAL SUPPORT

www.erico.com

IP8260_B

1 OF 2

INSTRUCTION SHEET

CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.

WARNING:

ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at

www.erico.com

and from your ERICO customer service representative.

ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.

All instructions must be

completely

followed to ensure proper and safe installation and performance.

Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property

damage, serious bodily injury and death.

SAFETY INSTRUCTIONS:

All governing codes and regulations and those required by the job site must be observed.

Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.

TDSGAPC14

Pipe Mount Grounding Bus

1 2

TDSGAPC14 1
IP8260_B 2

Résumé du contenu

Page 1 - TDSGAPC14

Clean surface of pipe using a T313 wire brush. Remove all paint and oxide layers.5/16-18 Hex NutApply 12 ft-lbs (Max)Apply anti-oxide compound at inte

Page 2 - IP8260_B

3/8-16 Acorn Nut3/8-16 Hex NutBelleville Washer3/8 Flat WasherTighten hex nut on rod connector. Apply 12 ft-lbs (Max)Note: In the absence of a torque

Commentaires sur ces manuels

Pas de commentaire

Erico TDSGAPC14 Pipe Mount Grounding Bus Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires pour les appareils électriques Erico TDSGAPC14 Pipe Mount Grounding Bus. ERICO TDSGAPC14 Pipe Mount Grounding Bus User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour les appareils électriques Erico TDSGAPC14 Pipe Mount Grounding Bus