Erico TDX100SM Manuel d'utilisateur télécharger pdf

Side Mounting Bracket

 2002 ERICO



Inc, 34600 Solon Rd, Solon, OH 44139 Page 1 of 1 Doc: HBCR1651, Rev: 2, Date: OCTOBER 28, 2002

TDX50SM

TDX100SM

Side Mounting Instructions

PREPARATION

DANGER: Electrical shock or burn hazard.

Installation of TVSS should be made by qualified

personnel. Failure to lockout electrical power

during installation or maintenance can result in fatal

electrocution or severe burns.

These installation instructions apply for the installation of the

TDX range of Surge Protectors onto the side of a Load Center

using the TDX Side Mounting Brackets. These instructions are

to be used in conjunction with the installation instructions for

the TDX product.

It is recommended that this installation use a 90° pulling elbow.

As dimensions of various manufacturers pulling elbows vary,

check fit before installing.

NOTE:

Separate Side Mounting Kits are available for either the TDX50

range of products or for the TDX100 & TDX150 range of

products. Please ensure that this kit is the correct model for the

application intended.

Each kit Contains:

a) 2 x Mounting Brackets

b) Instructions

Quick Installation

1. Disconnect and lockout electrical power to the electrical

panel (load center / panelboard / circuit breaker box) where

the TDX is to be installed. Follow all applicable electrical

codes and procedures.

2. Loosen side screws in both TDX end plates as shown in

Figure 1. Screws should be loosened on the side to be fixed

to load center only. Install TDX Side Mounting Brackets and

retighten TDX screws. There is no need to remove the

screws

3. Attach 90° Pulling Elbow (not included in this kit) to the

TDX unit.

4. Ensure panel is isolated and pre-drill holes for conduit

elbow and mounting screws. Align TDX unit and fasten to

Load Center with appropriate fasteners.

5. Complete electrical TVSS connection as per TVSS

instructions.

Side Mounting Instructions 1

Résumé du contenu

Page 1 - Side Mounting Instructions

Side Mounting Bracket  2002 ERICO Inc, 34600 Solon Rd, Solon, OH 44139 Page 1 of 1 Doc: HBCR1651, Rev: 2, Date: OCTOBER 28, 2002 TDX50SM TDX100

Modèles reliés TDX50SM

Commentaires sur ces manuels

Pas de commentaire

Erico TDX100SM Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires pour les appareils électriques Erico TDX100SM. ERICO TDX100SM User Manual Manuel d'utilisatio

Résumé du contenu

Modèles reliés TDX50SM

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour les appareils électriques Erico TDX100SM