Erico LPAW70ISOT ISODC "Y Splice" Manuel d'utilisateur télécharger pdf

Installation Torque:

220 in-lb [25 N-m]

Installation Tools:

5/16" Hex

Downconductor

Branch

Connector

60 mm

[2.36 in]

Downconductor

50 mm

[1.97 in]

Branch Connector

Installation Instructions:

Strip 60 mm [2.36 in] of insulation from the downconductor

and 50 mm [1.97 in] of insulation from the end of the

branch connector.

Remove oxides from bare conductors and connector

with wire brush. (Required for Aluminum; Recommended

for Copper)

Apply oxide inhibitor (Penetrox A-13 or equivalent) to

conductors and connector. (Required for Aluminum;

Recommended for Copper)

Apply threadlocker (Loctite

263

or equivalent)* to both

screw and connector threads.

Tighten screw to installation torque.

* Loctite

271

threadlocker can be used as a substitute for

Loctite

263

. Loctite

7649

activator needs to be applied

if using Loctite

271

TECHNICAL SUPPORT

www.erico.com

IP8216_A

1 OF 1

INSTRUCTION SHEET

CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.

WARNING:

ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at

www.erico.com

and from your ERICO customer service representative.

ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.

All instructions must be

completely

followed to ensure proper and safe installation and performance.

Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property

damage, serious bodily injury and death.

SAFETY INSTRUCTIONS:

All governing codes and regulations and those required by the job site must be observed.

Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.

Loctite is a registered trademark of Henkel Corporation

ISODC "Y" Splice

LPAW50ISOT & LPAW70ISOT

ISODC "Y" Splice 1

Résumé du contenu

Page 1 - ISODC "Y" Splice

Installation Torque:220 in-lb [25 N-m]Installation Tools:5/16" HexDownconductorBranchConnector60 mm[2.36 in]Downconductor50 mm[1.97 in]Branch Con

Commentaires sur ces manuels

Pas de commentaire

Erico LPAW70ISOT ISODC "Y Splice" Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires pour les appareils électriques Erico LPAW70ISOT ISODC "Y Splice". ERICO LPAW70ISOT ISODC "Y Splice" User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour les appareils électriques Erico LPAW70ISOT ISODC "Y Splice"