Erico SBG150 Rail Grinder Manuel d'utilisateur télécharger pdf (Page 14)

1. Unlock air filter cover by rotating twist lock counter clockwise.

2. Remove air filter cover by pulling up from the twist lock end of the cover.

3. Remove air filter.

4. Replacement: Insert air filter into air filter cover before reinstalling cover.

www.erico.com

AIR FILTER REMOVAL

AIR FILTER COVER

TWIST LOCK

AIR FILTER

GRINDING WHEEL REMOVAL

NOTE! For the following procedures, please reference the item numbers found in the exploded view of the tool model SBG150.

Corresponding items referenced below are found in brackets ( ). Follow the recommended torque schedule for

re-installation of fasteners.

1. Remove the Side Cover Wheel Guard (28) by removing the three mounting screws (29).

2. Remove locking pin (6) from main support (9) and insert into the hole in belt guard (16). Rotate grinding wheel until pin

slips into hole. See photo.

3. Using a 5/8” open-end wrench (supplied), loosen the wheel nut (22). NOTE! Rotate clockwise to loosen (left hand fastener)

and remove the grinding wheel.

4. Inspect all replacement wheels, ensure that they have not been dropped and/or abused.

5. Check to ensure that the paper blotters are present on each side of wheel, and that the wheel is an approved type by ERICO

6. Re-install in reverse order. Do not overtighten wheel nut (22). Follow torque schedule.

7. Replace locking pin (6) in main support.

8. Re-install side cover wheel guard (28) and start grinder. Allow grinding wheel to come up to maximum speed to verify

correct installation of wheel prior to grinding. Check installation if excessive vibration is present.

INSERT LOCKING PIN

HOLD WHEEL

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Erico SBG150 Rail Grinder Manuel d'utilisateur Page 14